Thursday, December 22, 2011

Safety Checklist For Electrical Work

Safety Checklist For Electrical Work


SAFETY CHECKLIST FOR ELECTRICAL
Safety Questionnaire


Yes
No



Do you specify compliance with OSHA for all contract electrical work?




Are all employees required to report as soon as practicable any obvious hazard to
life or property observed in connection with electrical equipment or lines?




Are employees instructed to make preliminary inspections and/or appropriate tests
to determine what conditions exist before starting work on electrical equipment or
lines?




When electrical equipment or lines are to be serviced, maintained or adjusted, are
necessary switches opened, locked-out and tagged whenever possible




Are portable electrical tools and equipment grounded or of the double insulated
type?




Are electrical appliances such as vacuum cleaners, polishers, and vending machines
grounded




Do extension cords being used have a grounding conductor?




Are multiple plug adaptors prohibited?




Are ground-fault circuit interrupters installed on each temporary 15 or 20 ampere,
120 volt AC circuit at locations where construction, demolition, modifications,
alterations or excavations are being performed?




Are all temporary circuits protected by suitable disconnecting switches or plug
connectors at the junction with permanent wiring?




Do you have electrical installations in hazardous dust or vapor areas? If so, do they
meet the National Electrical Code (NEC) for hazardous locations?






Is exposed wiring and cords with frayed or deteriorated insulation repaired or
replaced promptly?




Are flexible cords and cables free of splices or taps?




Are clamps or other securing means provided on flexible cords or cables at plugs,
receptacles, tools, equipment, etc., and is the cord jacket securely held in place?
Are all cord, cable and raceway connections intact and secure?




In wet or damp locations, are electrical tools and equipment appropriate for the use
or location or otherwise protected?




Is the location of electrical power lines and cables (overhead, underground, under
floor, other side of walls) determined before digging, drilling or similar work is
begun?




Is the use of metal ladders prohibited in areas where the ladder or the person using
the ladder could come in contact with energized parts of equipment, fixtures or
circuit conductors?




Are all disconnecting switches and circuit breakers labeled to indicate their use or
equipment served?




Are disconnecting means always opened before fuses are replaced?




Do all interior wiring systems include provisions for grounding metal parts of
electrical raceways, equipment and enclosures?




Are all electrical raceways and enclosures securely fastened in place?




Are all energized parts of electrical circuits and equipment guarded against
accidental contact by approved cabinets or enclosures?




Is sufficient access and working space provided and maintained about all electrical
equipment to permit ready and safe operations and maintenance?




Are all unused openings (including conduit knockouts) in electrical enclosures and
fittings closed with appropriate covers, plugs or plates?




Are disconnecting switches for electrical motors in excess of two horsepower,
capable of opening the circuit when the motor is in a stalled condition, without
exploding? (Switches must be horsepower rated equal to or in excess of the motor
hp rating.) Is low voltage protection provided in the control device of motors driving
machines or equipment which could cause probable injury from inadvertent
starting?




Is each motor disconnecting switch or circuit breaker located within sight of the
motor control device?
Is each motor located within




Is each motor located within sight of its controller or the controller disconnecting
means capable of being locked in the open position or is a separate disconnecting
means installed in the circuit within sight of the motor?




Is the controller for each motor in excess of two horsepower, rated in horsepower
equal to or in excess of the rating of the motor it serves?




Are employees who regularly work on or around energized electrical equipment or
lines instructed in the cardiopulmonary resuscitation (CPR) methods?




Are employees prohibited from working alone on energized lines or equipment over
600 volts?








No comments:

Post a Comment